How to update iUSBport/CloudFTP to support WebDav?

1. Download "cloudftp.app" at the end of this article.
2. Save it into a USB flash drive.
3. Insert the USB flash drive into the iUSBport/CloudFTP device and power it up.
4. Wait till the display screen shows "Refresh App?", press the power button once to confirm.
   
   
   
   
5. It will take a few minutes for the app refresh. Once it is done, the device will automatically restart 
   
   
6. Skip steps 7 to 13, if your firmware is later than V29. You can check the settings of the iUSBport/CloudFTP app for the firmware version. If you are still unsure of your firmware version, you can continue till step 12 to check the firmware version.
7. After the device finish restarting, remove the USB flash drive from the device.
8. Remove the "cloudftp" file from the USB flash drive.
9. Download "WD7START_V29.SEF.zip" at the end of this article.
10. Unzip it to a USB flash drive. The unzipped file is named "WD7START.SEF".
11. Insert the USB flash drive into the iUSBport/CloudFTP device and power it up.
12. Wait till the display screen shows "Update? VXX to V29". If XX is lesser than 29, press the power button once to confirm firmware update. If XX is greater than 29, you can do nothing to let the update message pass and skip to step 14.
    
    
13. It will take a few minutes for the firmware to update. Once it is done, the device will automatically start.
    
    
14. Once it is finished, the iUSBport/ CloudFTP device is ready to support WebDav.